DTH Instruments Disassembling Hammer Equipment by CZPT motor

Products Attribute
DTH Hammer Loosening Resources: The threaded connections of the driver chuck and top sub may become very tightly tensioned during drilling.It is convenient to break the hammer threads on the rig, but if the threads cannot be loosened or tend to get stuck, a DTH Hammer Assembling equipment is the solution.
This handy but powerful DTH Hammer Loosening Equipment / DTH Breakout Bench 
can easily be placed in a workshop or container and it breaks DTH hammers between 3.5”-8″.
 
There are two sorts of bench to disassemble the dth hammers.

Guide:
The procedure strategy as underneath:
1). Set hammer on the bench.
2). Adjust the position of the hammer and wrench use wrench to block the best sub aspect of hammer let wrench and jack in the same face.
three). Repair K-shaped base with nut.
4). Fix wrench with nuts.
five). Shake manage of jack slowly and gradually till best sub absent from hammer.
6). Soon after prime sub dismantled, grease the jack, launch nuts, discharge the K-formed foundation and turn close to the hammer.
seven). Modify the place of hammer and wrench use wrench to block the drive chuck of hammer permit wrench and jack in the exact same experience.
8). Correct hammer
nine). Repair K-shaped base and the wrench with nut.
ten). Shake handle of jack little by little until travel chuck away from hammer.
 
CZPT
The common motor ask for energy source with 3phase, 380V,50Hz. we can alter the motor as buyers ask for.
 

Specs
1. for disassembling the dth hammer 
2. effortless operation 
three. lower cost 
4. for 3″ to eight” hammers 

Major CZPT Data